Home > Industry > Causes Of Failure Of FAG Bearings

Causes Of Failure Of FAG Bearings

wallpapers Industry 2020-12-23

FAG's production line can meet these needs, and every part of the paper production line is equipped with FAG bearings. Since high-temperature steam passes through the roller of the bearing used in the dryer roll of the paper machine, the bearing must be in a high-temperature environment.
 
Therefore, due to insufficient lubrication film formation, the bearing may peel off early; long-term high-temperature use will cause creep due to aging; the temperature difference between the shaft and the inner ring will increase the stress, which may cause the bearing to fall off. Damage to the inner ring of the bearing. In particular, cracks in the inner ring can cause major accidents, leading to downtime.
 
In order to solve these problems, FAG has developed a high-hardness, long-life bearing. The bearing has been treated with special carbonitriding to improve the crack resistance of the inner ring and has dimensional stability at high temperatures. This imported FAG bearing has the highest reliability among similar products. As a special bearing for hydraulic cylinder rollers in the dryer section, it has established a solid position in the market.
Identification of radial ball bearings
 
For radial ball bearings with normal technical conditions, the raceways of the inner and outer rings should be free of flaking and severe wear marks, and should be a bright arc groove; all the balls should be round, and the surface should be free of spots, cracks and flaking; The cage is not loose, broken, or worn through.
 
 When holding the inner ring with one hand and pushing the outer ring quickly with the other hand, the rotation is required to be stable, and only a slight sound of rolling balls on the raceway is heard, without vibration; when stopping, it should be slowed down gradually and there is no backlash after stopping. For normal radial ball bearings, the gap between the inner and outer rings and the rolling elements is 0.005-0.010mm.



Say something
  • All comments(0)
    No comment yet. Please say something!
Tag: